Sliding Your Blanket Loom Across the Table? There’s a Better Way.

Let’s address the elephant in the room: your table.

You set your blanket loom on it, start making your blanket, and move the loom back and forth to reach the next section. It feels like a simple solution, until dragging the loom across the surface leaves scratches or marks.

Your table shouldn’t have to become the sliding mechanism for your loom. That’s where the Uppercase Designs Slide Top + Clamps Kit comes in.

Slide the loom on a system, not across your tabletop

The Slide Top attaches to a compatible table or counter using clamps. Your loom attaches to the Slide Top using slider pads, giving it side-to-side movement on the system rather than requiring you to drag the loom board across your furniture.

It’s a different approach to the same everyday need: bringing the next part of your blanket within reach.

Your loom moves. Your table isn’t the track.

If you’re already shifting your loom across the table, you know why movement matters. You want to reach across your project without continually moving your chair or stretching farther along the board.

The Slide Top gives that movement a dedicated place. It supports your loom while you slide it side to side, leaving both hands free to make your blanket instead of holding the loom yourself.

Use the table you have

You don’t need Pivoting Legs to use the Slide Top + Clamps Kit. The included clamps attach it directly to a suitable table or counter.

The standard clamps fit surfaces ½–2 inches (1.3–5.1 cm) thick and up to 1⅞ inches (4.8 cm) deep. The minimum table or counter width is 39 inches (99.1 cm). Check the edge and underside as well as the tabletop before choosing your setup.

The product page explains the included parts and fit requirements, so you can choose around your furniture rather than guessing.

Need your table back? Keep your project together.

When it’s time to clear the table, undo the clamp levers, lift the assembled setup off, and place it somewhere suitable. Your loom, Slide Top, and blanket project can stay together.

You don’t have to take your blanket off the loom just because you need the table for something else. Bring the setup back and secure it again when you’re ready to continue.

An upgrade for the loom you already enjoy

All Uppercase Designs looms are compatible with the Slide Top + Clamps Kit. The loom is sold separately, so if you already own one, this is a way to build on your existing setup.

You can also add Pivoting Legs later if you decide you want a freestanding arrangement. Your first upgrade doesn’t have to be your final setup.

Make your blanket, not more marks on your table

If moving your loom means dragging it back and forth across your furniture, it’s time to consider a dedicated sliding setup. Keep the movement where it belongs: on the Slide Top.

Explore the Slide Top + Clamps Kit and check the fit for your table.

Slide Baby Slide.

The Original Creator of the Chunky Blanket Loom™

Questions? info@UppercaseDesigns.ca | Toll-free: 1-888-860-7735.